Page 1 Interface user guide This guide details the Command Line Interface ( CLI which is used to configure and manage the following products: — HP Storage Works 1000 Modular Smart Array ( MSA1000) — HP Storage Works 1500 Modular Smart Array ( MSA1500) Part number: 347282–004. Page 2 Hewlett- Packard. The information is provided “as is” without warranty of any kind and is subject to change without notice. The only warranties for HP products and services are set forth in the express warranty statements accompanying such products and services. Page 3: Table Of Contents HP-authorized reseller. Page 4: Table Of Contents Basic command.29 Command options. Page 5: Table Of Contents Index. 51 HP Storage Works 1000/1500 Modular Smart Array Command Line Interface user guide. Page 6: Table Of Contents Figures Multiple physical drives ( D1, D2, and D3) in a system.45 Multiple physical drives ( D1, D2, and D3) configured into one logical drive ( L1). Page 7: About This Guide, Intended Audience, Related Documentation, Document Conventions And Symbols, Document Conventions • HP Array Configuration Utility user guide • Configuring Arrays on HP Smart Array Controllers reference guide These and other HP documents can be found on the HP documents website: Document conventions and symbols Table 1 Document conventions Convention. Page 8 WARNING! Indicates that failure to follow directions could result in bodily harm or death. CAUTION: Indicates that failure to follow directions could result in damage to equipment or data. IMPORTANT: Provides clarifying information or specific instructions. NOTE: Provides additional information. TIP: Provides helpful hints and shortcuts. Page 9: Hp Technical Support, Hp-authorized Reseller, Helpful Websites • Detailed, specific questions For continuous quality improvement, calls may be recorded or monitored. HP strongly.
Powering off and powering on the MSA NOTE: To restart (power-cycle) the MSA, follow the procedures below to power off and then power on the array. Powering off the MSA NOTE: System power to the MSA array does not completely shut off with the Power on/ Standby button. The Standby position removes power from most of the electronics and components, but portions of the power supply and some internal circuitry remain active. To completely remove power from the system, disconnect all power cords from the device. IMPORTANT: that all I/ O activity on the hard drives is ceased before powering off the hard drive enclosure. Schedule a maintenance window. Ensure that a known good backup is available. Power down all servers with access to the MSA, or if your operating system fully supports it, quiesce all I/ O and dismount all LUNs. On the MSA, press and hold down the Power on/ Standby button on the front of the chassis for approximately five seconds to place the MSA array in Standby mode. Verify that the Power on/ Standby button LED is amber/off and that the fans are off. Power off all attached hard drive enclosures. Disconnect the power cords from the MSA. It is critical to shut down the MSA array before the hard drive enclosures, to ensure HP Storage Works 1000 Modular Smart Array installation guide Verify that the following devices are powered on and in a ready state: • Uninterruptible Power Supplies ( UPS) • External Fibre Channel switches Power on all attached storage enclosures. IMPORTANT: enclosures have completed their startup routines; otherwise, the MSA array may not properly discover the storage. Wait for the storage enclosures to complete their startup routines. Press and release the Power on/ Standby button on the front of the chassis to start the MSA array. The LED on the Power on/ Standby button changes from amber to solid green, indicating that the MSA has been powered.
Download Now